Rohde & Schwarz ESRP Series, Руководство пользователя

Страница: 166 / 1094

Receiver Mode
R&S
®
ESRP
163 User Manual 1175.7445.02 ─ 08
5.3.6 Controlling Inputs and Outputs
The input/output settings are available in the [Input/Output ] menu.
For information on the LISN control see Chapter 5.3.7.6, "LISN Settings" ,
on page 172.
Input (AC/DC) ..............................................................................................................163
User Port ..................................................................................................................... 163
Input (AC/DC)
Toggles the RF input of the R&S ESRP between AC and DC coupling.
Remote command:
INPut:COUPling
on page 641
User Port
The user port (AUX port) can transmit bit patterns in two directions, depending on the
actual selected signal direction. The user port is available on the rear panel when you
equip the R&S
ESRP with option R&S ESRP-B5.
●
"Direction" = "In" (read only)
Opens a dialog box. Select the "Read" button to read out the user port configura-
tion. The value is displayed in the dialog box.
●
"Direction" = "Out"
Select the required bit pattern by changing the state of the individual ports ("Port
<x>").
See
"AUX PORT" on page 35 for information about the pin assignment of the con-
nector.
See
OUTPut:UPORt[:VALue]
on page 901 for information about the pin to bit
assignment.
Remote command:
State:
INPut<ip>:UPORt:STATe
on page 900
State:
OUTPut:UPORt:STATe
on page 901
Bit pattern (query):
INPut<ip>:UPORt[:VALue]
on page 900
Bit pattern (setting):
OUTPut:UPORt[:VALue]
on page 901
5.3.7 Test Automation
The test automation settings are availbale in the [MEAS] and [MEAS Config] menu.
The Test Automation dialog box contains functionality to configure automated test
sequences.
It is made up of several tabs, each of which contains the settings for one of the stages
in an automated test sequence (see also
Chapter 5.1, "Measurements and Result Dis-
plays" , on page 119).
The "Peak Search" and "Run Final Test" buttons at the bottom of each of the tabs ini-
tiate the corresponding measurement function.
SCPI command:
Common Measurement Settings