Rohde & Schwarz ESRP Series, Руководство пользователя

Страница: 136 / 1094

Receiver Mode
R&S
®
ESRP
133 User Manual 1175.7445.02 ─ 08
The Spectrogram of the Scan is independent of the Spectrogram available for IF
Analysis and vice versa. Therefore you should regard the two Spectrograms as sepa-
rate result displays. For more information see
Chapter 5.1.6, "Spectrogram" ,
on page 127.
Remote command:
CALCulate<n>:FEED
on page 606
Ba Scan
Shows the Bargraph and Scan result displays.
Ba IF Analysis
Shows the Bargraph and IF Analysis result displays.
Bargraph
Turns the Bargraph result display on and off.
IF Analysis
Turns the IF Analysis result display on and off.
Scan
Turns the Scan result display on and off.
Spectrogram
Turns the Spectrogram result display on and off.
5.1.7.3 Bargraph Control
The "Measurement Configuration" menu contains functionality to configure the bar-
graph.
SCPI commands:
Querying the signal level:
"Querying bargraph results" on page 613
Querying the upper and lower value of the bargraph scale:
DISPlay:BARGraph:LEVel:LOWer?
on page 607
DISPlay:BARGraph:LEVel:UPPer?
on page 607
Continuous Bargraph / Single Bargraph ..................................................................... 133
Bargraph Maxhold .......................................................................................................134
Maxhold Reset ............................................................................................................ 134
Continuous Bargraph / Single Bargraph
Selects single or continuous bargraph measurements.
Continuous bargraph measurements continuously evaluate the signal level at the
receiver frequency.
Measurements and Result Displays