Rohde & Schwarz ESRP Series, Руководство пользователя

Страница: 175 / 1094

Receiver Mode
R&S
®
ESRP
172 User Manual 1175.7445.02 ─ 08
The measurement time is the time during which the R&S ESRP measures the input
signal and forms a measurement result weighted by the selected detector. The mea-
surement time does not include settling times of the synthesizer and the IF filter. The
R&S
ESRP automatically waits until transients are over.
Interactive Mode
Turns interactive final measurements on and off.
Remote command:
[SENSe:]FMEasurement:AUTO
on page 612
Trace 1 to 6
Selects the characteristics of each trace.
In addition to the trace mode, you can select a detector for the scan and the final mea-
surement. For more information see
●
Chapter 5.1.3, "Scans" , on page 121
●
Chapter 5.1.5, "Final Measurement" , on page 126
●
Chapter 5.2.3, "Trace Modes" , on page 147
●
Chapter 5.2.2, "Detectors" , on page 143
Note: When you select detector type "None" for the final measurement, the
R&S ESRP ignores peaks found on the corresponding trace during the final measure-
ment.
Remote command:
Trace mode:
DISPlay[:WINDow<n>]:TRACe<t>:MODE
on page 652
Scan detector:
[SENSe:][WINDow:]DETector<trace>[:FUNCtion]
on page 651
Final measurement detector:
[SENSe:]DETector<t>:FMEasurement
on page 611
5.3.7.6 LISN Settings
The "LISN Settings" tab in the "Test Automation" dialog box contains functionality to
control line impedance networks.
Common Measurement Settings