Rohde & Schwarz ESRP Series, Руководство пользователя

Страница: 615 / 1094

Remote Control
R&S
®
ESRP
612 User Manual 1175.7445.02 ─ 08
[SENSe:]FMEasurement:AUTO <State>
This command turns automatic final measurements on and off.
Parameters:
<State> ON
Turns on automatic final measurement.
OFF
Turns on interactive final measurement.
*RST:
ON
Example: FME:AUTO ON
Manual operation: See "Automatic Final" on page 137
See "Interactive Final" on page 137
See "Interactive Mode" on page 172
[SENSe:]FMEasurement:TIME <Time>
This command defines the time each frequency in the peak list is measured during the
final measurement.
Parameters:
<Time> *RST: 1 s
Example: FME:TIME 1us
Defines a measurement time of 1 µs.
11.4.1.5 Trace Data and Result Query
This section contains information on the
TRACe:DATA
command and a detailed
description of the characteristics of that command. Basically, the command queries the
results of the current measurement. The command supports various SCPI parameters
in combination with the query. Each SCPI parameter returns a different aspect of the
measurement.
The format of the return values is either in ASCII or binary characters and depends on
the format you have set with
FORMat[:DATA]
on page 818.
Querying trace data
The SCPI parameters
TRACE1
| ... |
TRACE6
return the trace data for the correspond-
ing trace.
Example:
TRAC? TRACE1
The number of results depends on the currently selected number of sweep points. For
each sweep point, the command returns one level value. The unit depends on the
measurement and on the unit you have currently set.
The trace has to be active for the command to work.
Remote Commands in Receiver Mode