Chapter 6: Using the Web Interface
227
Static Route Examples
This section describes two static route examples: IPv4 and IPv6. Both
examples assume that two network interface controllers (NIC) have been
installed in one network server, leading to two available subnets, and IP
forwarding has been enabled. All of the NICs and PX3 devices in the
examples use static IP addresses.
Most of local multiple networks are not directly reachable and require
the use of a gateway. Therefore, we will select Gateway in the following
examples. If your local multiple networks are directly reachable, you
should select Interface rather than Gateway.
Note: If Interface is selected, you should select an interface name
instead of entering an IP address. See
Interface Names
(on page 230).
IPv4 example:
Your PX3:
192.168.100.64
Two NICs:
192.168.200.75 and 192.168.100.88
Two networks:
192.168.200.0 and 192.168.100.0
Subnet mask:
24
Содержание PX3-1000 series
