Vista 5 M3 Digital Mixing System
RELINK 8-11
Document generated: 28.08.13
SW V4.9
Start ‘
Config tool for DNet applications
’ in the Vista console’s C drive
(C:\Release ConfigTool\ConfigTool.exe)
Select one of the DNet systems available in the network, select the appropriate
Vista system.
If the Vista or the other connected systems are not appearing, please refer to
chapter 7.2
to verify the settings in the
Container.ini
file.
In the configuration tool, go to
Physical Connections
. Under
Destination
all HD links within your system are listed.
Select the physical inputs to be used as tie lines. Once they are configured as
tie lines, they will no more be visible in the Vista general patch.
Configuration
always takes place on the consumer system (target system).
Only the tie line
inputs need to be configured, i.e., the tie lines that are directed
towards
our
system. The tie lines that go away
from
our system are configured as inputs
on the other systems, such as the router.
Select the appropriate
system
(e.g. the Star router, as shown below):
Summary of Contents for Vista 5 M3
