Studer Vista 5 M3, Operating Instructions Manual

Page: 100 / 564

Vista 5 M3 Digital Mixing System
3-12 Parameters
Document generated: 28.08.13 SW V4.9
3.3.5 Stereo AUXes
Press one of the
GLOBAL VIEW: AUX STEREO
keys.
The stereo AUX view provides selection of the AUX bus (ON/OFF), send
level adjustment, pre-/after-fader switching, and pan setting. From 5.1 sur-
round channels, stereo AUX sends are fed with an ITU-compatible stereo
down-mix.
Aux s x On/Off Stereo AUX bus selection. Other stereo AUX bus views can be selected as
well (5...8, 9...12, etc.).
Aux s x Rotary The send levels for stereo AUX buses can be adjusted using this rotary
encoder; adjustment range is from MUTE (i.e. –
∞
) t10 dB.
AUX s x Pre/Post When the
PRE / POST
key in the fader bay’s
GLOBAL VIEW
area is active,
the Vistonics view changes similar to the one shown above in the center. The
signal sent to the stereo AUX bus can be selected from Pre (pre-fader, i.e.
before
the fader) or
Post
(post-fader, i.e.
after
the fader).
AUX s x Pan Rotary The Stereo Aux Pan view is activated by pressing the
PAN
key below the
GLOBAL VIEW - AUX
keys. By default, the Aux panner is linked to the channel
pan value (Follow On), as shown above at the right. If the channel panning
is ‘multi-format’, only the L/R setting is used for the Aux pan.
AUX s x Follow On/Off If individual Aux pan settings are required, the default setting (‘Follow On’,
i.e. the Aux pan setting follows the channel pan) may be switched off; the
Aux panner is then adjusted with the Vistonics rotary encoder.