Studer Vista 5 M3, Operating Instructions Manual

Page: 275 / 564

Vista 5 M3 Digital Mixing System
GC Operation 4-131
Document generated: 28.08.13 SW V4.9
Enabling Pro-Bel Setup In order to activate and see the
Setup Pro-Bel
button on the General Patch
window, the system has to be in SysAdmin mode. The SysAdmin menu con-
tains a General Patch sub menu and a
Use Pro-Bel on General Patch
item.
This setting will be written to the
D950System.ini
as well, resulting in
the same behavior as if it was edited by hand in the first place. The button
will then be visible whenever the system enters SysAdmin mode.
Enabling COM Ports for Use with the Pro-Bel Protocol
Ports that are used for Pro-Bel need to be specified in
D950System.ini
in the
[d950SerialPorts]
section. This gives the possibility to use non-
standard data rates and parity settings.
[d950SerialPorts]
1= {p} COM1 baud=115200 parity=N data=8 stop=1
2= {b} COM6 baud=38400 parity=E data=8 stop=1
‘b’ is used to indicate Pro-Bel use. Only the COM ports defined in this way
will be available in the Pro-Bel set-up dialog.
Pro-Bel Set-up Dialog With
Use Pro-Bel on General Patch
enabled, the General Patch displays an
additional button on the bottom right.
When clicking on this button the system brings up the set-up dialog and enters
Pro-Bel set-up mode.