Omron CP1H CPU UNITS - PROGRAMMING 05-2007, Operation Manual

Page: 566 / 788

532
Installation and Initial Setup
Section 9-8
3. For CPU Units with 30, 40 or 60 I/O points, switch DipSW4 of the CPU unit
to ON, if the Ethernet Option Board is mounted on the Option Board slot 1
(left side). Switch DipSW5 of the CPU unit to ON, if the Ethernet Option
Board is mounted on the Option Board slot 2 (right side).
For CPU Units with 14 or 20 I/O points, switch DipSW4 of the CPU unit to
ON.
Note DipSW4 and DipSW5 are OFF at shipment.
Removing
Press the up/down lock-levers on both sides of the Ethernet Option Board at
the same time to unlock the Ethernet Option Board, and then pull it out.
9-8-3 Network Installation
Basic Installation Precautions
• Take the greatest care when installing the Ethernet System, being sure to
follow ISO 802-3 specifications. You must obtain a copy of these specifi-
cations and be sure you understand them before attempting to install an
Ethernet System. Unless you are already experienced in installing com-
munications systems, we strongly recommend that you employ a profes-
sional to install your system.
• Do not install Ethernet equipment near sources of noise. If noise-prone
environments are unavoidable, be sure to take adequate measures
against noise interference, such as installing network components in
grounded metal cases, using optical links in the system, etc.
ON
1
2
34
56
DipSW4
DipSW5
Press
Press
Lock lever
Lock lever