![Intel 8XC196NT User Manual Download Page 334](http://html1.mh-extra.com/html/intel/8xc196nt/8xc196nt_user-manual_2072210334.webp)
14-15
INTERFACING WITH EXTERNAL MEMORY
14.4.3 8-bit Bus Timings
When the device is configured to operate in the 8-bit bus mode, lines AD7:0 form a multiplexed
lower address and data bus. Lines AD15:8 are not multiplexed; the upper address is latched and
remains valid throughout the bus cycle. Figure 14-7 shows an idealized timing diagram for the
external read and write cycles. One cycle is required for an 8-bit read or write. A 16-bit access
requires two cycles. The first cycle accesses the lower byte, and the second cycle accesses the
upper byte. Except for requiring an extra cycle to write the bytes separately, the timings are the
same as on the 16-bit bus.
The ALE signal is used to demultiplex the lower address by strobing a transparent latch (such as
a 74AC373).
For 8-bit bus read cycles, after ALE falls, the bus controller floats the bus and drives the RD#
signal low. The external memory then must put its data on the bus. That data must be valid at the
rising edge of the RD# signal. To read a data word, the bus controller performs two consecutive
reads, reading the low byte first, followed by the high byte.
For 8-bit bus write cycles, after ALE falls, the bus controller outputs data on AD7:0 and then
drives WR# low. The external memory must latch the data by the time WR# goes high. That data
will be valid on the bus until slightly after WR# goes high. To write a data word, the bus controller
performs two consecutive writes, writing the low byte first, followed by the high byte.
Summary of Contents for 8XC196NT
