GSK GSK988TA, Manual

Page: 489 / 531

Appendix 4 Alarm Troubleshooting
471
Appendix
Alarm
No.
Meaning Possible Alarm Reason Troubleshooting
301
P address error in
multi-spindle
selection
When select spindle in
multi-spindle control function, P
address assigns an illegal value
beyond the range set in
Para.No.3781
302
Absence of P
address in
multi-spindle
selection
In multi-spindle selection, P
address with spindle speed
command S is absence. The
alarm is release when
Para.No.3706#2 is set to 0
303
Error multi-spindle
function disabled
1.Para.MPP
（
No.3703#3
）
=0,while specify P address to
select
spindle\n2.Para.MPS(No.3781)=
0
，
while specify P address to
select spindle
310
Illegal polygon
processing
command in C-type
tool compensation
mode
In C-type tool compensation
mode(None-G40 mode), while
specify polygon processing
commandG51.2(251)
311
G51.2 repetition in
polygon processing
In the G51.2 polygon machine
mode, the command, G51.2, is
specified again.
312
Error found in P
address of G51.2 P is not specified or set by a
value out of range in G51.2
313
Error found in Q
address of G51.2 Q is not specified or set by a
value out of range in G51.2
314
PQ ratio incorrect
P/Q is not equal to 0 refer to
param7603#1.
315
G51.2 is not
performed in
polygon processing When Para.No.7610 is set to
0,polygon processing command
G51.2 is not used
316
Rotation axis set
error The shaft axis of rotation is not
set
317
Conflict code
specified in the
same block with
G51.2 or G50.2
G51.2 or G50.2 is specified in the
same block with other G or MT
instructions
318
polygon processing
instructions of the
screw mosquito
instructions
Polygon processing, command a
mosquito Lo instructions
319
polygon processing
command axis
command is illegal Polygon processing, command
the tool rotation axis move
command
320
polygon rotation
axis machining
work is no
instruction S
instruction position
mode
Polygon rotation axis of the
workpiece machining way to
position mode (para. 7603 #4),
there is no instruction S
command.