GSK GSK988TA, Manual

Page: 483 / 531

Appendix 4 Alarm Troubleshooting
465
Appendix
Alarm
No.
Meaning Possible Alarm Reason Troubleshooting
100
Chamfering
amount, J was
specified error in
thread cutting
commands
Value of J address exceeds
permissive range, or the number
followed J is less than zero in
G92, G76
101
Chamfering amount
K was specified
error in thread
cutting commands
Chamfering amount specified by
K is less than zero, or exceeds
permissive range
102
Value of L out of
range in
multi-threading The value specified in L exceeds
the range(1~99) in
Multi-threading
103
Illegal lead
command Lead specified by F is out of
range
104
Value of R out of
range in variable
threading
In variable threading, the lead
incremental and decremental
specified by R exceeded
permissive range
105
Chamfering amount
too large of long
axis in threading
Chamfering amount of long axis
was greater than thread length;
alternatively, the long axis
end-retraction value calculated
by leading F and parameter 5130
is excessive big in the G92/G76
command.
106
Chamfering amount
too large of latitude
axis in threading
Chamfering amount of latitude
axis in G92 was greater than the
distance between start point and
end point
107
Axes not in
selected plane in
threading Specify the axis out of the
selected panel in thread
command.
108
Illegal axes for
interpolation in
threading In threading, basis and parallel
axes are both specified, or more
than 2 parallel axes are specified
109
C axis not exist in
rigid threading C axis is not set in parameter
No.1020 for rigid threading
110
C axis is not
rotation type in rigid
threading C axis is not rotation type in rigid
threading, Refer to parameter
No.1006#0 and 1006#1.
111
Spindle speed S not
specified in rigid
threading
S address was not specified for
rigid threading command G32.1
130
Illegal plane select
In the plane selection command,
two or more axes in the same
direction are selected
131
Illegal basic axis
specified for
selected plane