GSK GSK988TA, Manual

Page: 63 / 531

Chapter 2 G Commands
45
Ⅰ
Programming
2.8 Programmable Parameter Input G10
2.8.1 Workpiece Coordinate System Offset
Command function: the assumed workpiece during programming deviates from the coordinate
system actually set by G50. The expected offset amount set by the
workpiece coordinate system makes the set coordinate system offset.
Command format ： G10 P0 IP_;
Command explanation
：
P0
：
workpiece coordinate system’s offset code
IP_ ： setting value of axis address and workpiece coordinate system’s
offset amount
An absolute code is the offset amount of the previous workpiece coordinate system; an
incremental code is the offset amount of the current workpiece coordinate system.
Z
z
x
X
o`
O
X-Z ： The assumed coordinate system when programming
x-z: With offset amount, the current set coordinate system
（
revise the coordinate system by an offset
）
The offset amount from o` to O is set in the
corresponding workpiece coordinate system
’
s
offset setting in the coordinate setting page
Fig. 2-10 Workpiece coordinate system offset
Relationship between coordinate offset and each coordinate:
Note 1
：
In a program, even if X
，
Y
，
Z
，
C
，
U
，
V
，
W
，
H are in the same block
，
the later specified code is
Offset