GSK GSK988TA, Manual

Page: 71 / 531

Chapter 2 G Commands
53
Ⅰ
Programming
Fig.2-13
Note 1: The modal G22/G23 in group 9 can be set by No. 3402 Bit 7(G23);
Note 2: G22 stored travel check is limited to the stored travel limit check 2, and the detailed is referred to
OPERATION;
Note 3: The data is set by the distance (least code increment is taken as the unit) to the reference position
when the parameter sets the top point of the forbidden area;
Note 4: Whether the limit range is the inner side or outer side of the area is set by No. 1300 Bit0 (OUT) , and it
is the inner side when it is set to 0;
Note 5: The limit is valid after the system executes the reference position return; the system alarms when the
reference position is in the limit area in G22 mode;
Note 6: The tool reversely traverses when the travel alarm occurs, and the alarm is cleared after reset again;
Note 7: G22/G23 is executed in an alone block, and an alarm occurs when it and other G codes or MST are in
the same block;
Note 8: When the system is switched from G23 to G22 in the forbidden area, an alarm occurs;
Note 9: When No.1310 Bit 0(OT2x) of the stored travel limit check 2 is set to 1(executing the stored travel limit
2 check), the system executes G22 and then the check; the system does not execute the check when it
is G23;
2.12 Skip Interpolation G31
Command function: In the course of executing the code, when the outside skip signal (X0.4) is
input, the system stops the code to execute the next block.
The function is used to the dynamic measure (such as milling machine),
toolsetting measure and so on of workpiece measure.
Command format
：
G31 IP_ F_
；
Command explanations: non-modal G code (00 group); its address format is same that of G01;
Cancel the tool nose radius compensation before using it; feedrate should not be set to too big to
get a precise stop position;
The following block execution when skipping:
1
．
The next block of G31 is the incremental coordinate programming, which is shown in Fig. 2-14.