GSK GSK988TA, Manual

Page: 305 / 531

Chapter 4 Editing and Managing the Program
287
Ⅱ
Operation
, , occur.
: The character string can be rapidly found by pressing the key and the cursor is
positioned behind the character string which has been searched. During searching, the three
searching modes of , and can be selected.
: After the program is edited, press software key to check
whether the program has the syntax error; if it has, the reminder will occur below the screen, and
the program should be checked and rewritten based on the reminder.
Note:
1 ： When the parameter 3404.6 is 0, the program must be with the end code, like M02, M30 or M99, etc;
Otherwise, the system reminds the error during checking the program after pressing
software key, and the alarm occurs when the program is started.
2
：
The big file exceeding 10,000 lines can’t be edited.
3 ： Besides manually saving programs, the CNC system owns an automatic save function during the course
of edit, and it automatically saves files every 90 seconds.
：
the CNC system owns an automatic save function. To count some points during
programming, press the soft key , and the system pops up a counter which is shown in
Fig.4-6.
Fig.4-6
: The system is with the calculator. If calculation is required during programming,
software key is pressed, the calculator will be popped up.