Chapter 3 Display Page
243
Ⅱ
Operation
to enter the corresponding setting, and input the password corresponding to the
operation level, so the operation authority corresponding to the level is obtained. On the password
setting page, the operation password of the level or that lower than the level, the current password
level can also be degraded.
The authority level doesn’t remain after power off at operation authority level 1 or 2, and the
operation level 3 is entered after power on, again. The operation authority of 3
~
5 levels remain after
power off, and the operation authority level before power off is restored after power off, again.
When the authority isn’t enough, the reminder is popped up to remind that the corresponding
operation authority isn’t enough. In Auto mode, the operation authority executed by the program isn’t
enough, the machine movement should be stopped and the alarm occurs.
(
1
)
Entering the authority level
Press
software key to reduce the operation level and the current operation
authority level is displayed in the operation authority column of the window.
Press
software key to input the password of the corresponding level to enter the
corresponding operation level.
Note: The initial password relation corresponding each authority level is shown in the following list.
Operation
level
Initial password
Level 1
***
Level 2
***
Level 3
333333
Level 4
444444
Level 5
Without operation password
(
2
)
Rewriting the password
Firstly, the operation authority level for rewriting the password should be entered; press
software key to rewrite the system current authority password. Input the new and old
passwords in
edit box, and the cursor can be switched
between the new and old password edit boxes by pressing
, and finally press
to complete rewriting the password.
Summary of Contents for GSK988TA
