GSK GSK988TA, Manual

Page: 449 / 531

Appendix 1 Parameters
431
Appendix
6710
M codes counting the total quantity of the processing parts and
the quantity of the processing parts (MPC)
『
Modification authority
』
: Machine
『 Value Range 』 : 0 ～ 9999
『
Default Setting
』
: 0
The machine program executes M codes set by the parameter, total quantity of the processing parts
and quantity of the processing parts plus 1, respectively.
Note:When the setting value is 0, it is invalid (M00 can’t count the parts). And it can’t be set as 98 and 99,
198, neither.
6713 Quantity of the required parts (RPM)
『
Modification authority
』
: Machine
『 Value Range 』 : 0 ～ 9999
『
Default Setting
』
: 0
When the quantity of the processing parts equals to that of the parts required being processed, the
signal PRTSF (F62.7) of the enough quantity of the required parts outputs to PLC. However,
Note: If the quantity is 0, it is regarded as infinitely great, not output to PRTSF.
Appendix 1.23 Parameter for Tool Life Span Administration
#7 #6 #5 #4 #3 #2 #1 #0
6800 GRC GPS SIG LTM GS2 GS1
『
Modification authority
』
: Equipment management
『
Validate method
』
: After power-on
『
Default Setting
』：
0000 00000
#0 GS1 The registered group numbers and the tool numbers of each 1 group can be
changed by setting the parameters GS1, GS2 based upon the Max. group number in the
parameter 6813.
#1 GS2 The registered group numbers and the tool numbers of each 1 group can be
changed by setting the parameters GS1, GS2 based upon the Max. group number in the
parameter 6813.
The relationships between GS1, GS2 and tool numbers are shown below:
GS2 GS1 Group Number Tool Number
0 0 The 1/8 from the 1 to the Max. group number (No.6813) 1~16
0 1 The 1/4 from the 1 to the Max. group number (No.6813) 1~8