GSK GSK988TA, Manual

Page: 81 / 531

Chapter 2 G Commands
63
Ⅰ
Programming
Note 3: Use the following method to change:
1
）
MDI input changes the workpiece coordinate system zero;
2
）
Use G50 to move the workpiece coordinate system;
Specifying G50 IP_ makes the workpiece coordinate system （ G54 ～ G59 ） to set a new workpiece
coordinate system where the current tool position is consistent with the specified coordinates. When G50
specifies the relative value, the value adding the previous tool position coordinate value creates a new
coordinate system, but the tool position does not change but the coordinate system executes the offset
as Fig. 2-24:
Fig.2-24
Note 4: The coordinate offset value created by G50 adds to the one of all workpiece zero to make ensure
that all workpiece coordinate systems offset are the same value as Fig. 2-25:
Fig. 2-25
Note 5: The workpiece zero offset value of G54
～
G59 workpiece coordinate system can be set in the
parameters and input in the coordinate setting window;
2.15.4 Additional Workpiece Coordinate System G54.1
Command function: The system uses 6 standard workpiece coordinate systems (G54~G59) and
can use 48 additional workpiece coordinate systems.