GSK GSK988TA, Manual

Page: 337 / 531

Chapter 7 Tool Offset & Tool Setting
319
Ⅱ
Operation
Chapter 7 Tool Offset & Tool Setting
To simplify programming, the actual position of the tool isn’t included during programming;
GSK988TA/988TA1/988TB provides the tool setting method, like tool setting in the fixed position and
the trial tool cutting, and the tool offset data can be acquired by tool setting.
7.1 Setting the Tool Offset Value and Wearing Value
7.1.1 Direct inputting Method
（ 1 ） On the setting page set, press software key to enter the tool offset
administration page, which is shown as Fig. 7-1:
Fig.7-1
（ 2 ） On the page, press the page up key and page down key to select the page,
press the up/down direction keys , to select the tool offset number to be rewritten and
press the left/right direction keys , to select the axis tool offset data, the wearing data to
be rewritten or T value in the assumed tool nose direction, which is like X axis offset of #001 tool
offset in the above figure; About the corresponding relation of the assumed tool nose, refer to
The
Programming Manual
.
（
3
）
The tool offset data, the wearing data or the corresponding assumed tool nose direction
number T can be directly rewritten with the digit key and the backspace key; or the selected tool offset
value can be input by pressing key, which is like X axis offset of the tool offset of #001 in Fig.
7-2, and then the tool offset data, the wearing data or the corresponding assumed tool nose direction
number T can be rewritten with the digit key and the backspace key;