GSK GSK988TA, Manual

Page: 424 / 531

GSK988TA/GSK988TA1/GSK988TB Turning Center CNC System User Manual 【 Programming & Operation 】
406
Appendix
maximum speed set by the parameter when the commanded spindle speed exceeds the maximum
spindle speed, or the spindle speed after override exceeds the maximum spindle speed.
Note: 1. When the constant surface speed controls, no matter whether G96 or G97 is commanded, the
spindle speed is limited by the maximum spindle speed.
2. When the setting value is 0, it is not limited by the speed.
3775
The default spindle in the multi-spindle selects the P command
value (MPD)
『
Modification authority
』
: System
『 Validate method 』 : After power-on
『
Value Range
』：
0
～
99
『
Default Setting
』：
0
In the multi-spindle control, when parameter MPP(NO.3703#3)=1 and MPA
（
NO.3706#2
）
=1; there is no specification for the P command value in the command S_ P_ after the power is
turned on.
3781
In multi-spindle control, when code P is used for spindle selection
(MPS)
『
Modification authority
』
: System
『 Validate method 』 : After power-on
『 Value Range 』： 0 ～ 99
『
Default Setting
』：
0
When MPP(NO.3703#3)=1
，
In multi-spindle control, code P used for spindle selection is set with
the parameter. And P code and S commands are specified in the same block
#7 #6 #5 #4 #3 #2 #1 #0
4900 SFLR
『
Modification authority
』
: Equipment management
『
Parameter Type
』：
Bit axis
『 Default Setting 』： 0000 0000
#0 SFLR The setting unit of parameters 4911 and 4912 during the FLR in the spindle speed
fluctuation detection function.
0
：
1% is regarded as the unit
1 ： 0.1% is regarded as the unit