GSK GSK988TA, Manual

Page: 436 / 531

GSK988TA/GSK988TA1/GSK988TB Turning Center CNC System User Manual 【 Programming & Operation 】
418
Appendix
5142 Finishing cycle times of G76 combined canned cycle (G76FC)
『
Modification authority
』
:Equipment management
『 Value Range 』 : 1 ～ 99
『
Default Setting
』
: 1
Set the finishing cycle times of G76 combined canned cycle.
5143 Tool nose angle of G76 combined canned cycle (G76TNA)
『
Modification authority
』
:Equipment management
『 Value Range 』 : 0 ～ 99 (deg)
『
Default Setting
』
: 60
Set the tool nose angle of G76 combined canned cycle.
5149
Override value for retraction in boring cycles (G85, G89)
(BCRDOV)
『 Modification authority 』 :Equipment management
『
Value Range
』：
0
～
2000
『
Default Setting
』：
200
Set the velocity override value (%) of the retraction operation in boring cycle, it is separately
enabled to the feedrate. When this speed sets to 0, it equals to the 200% speed override.
Appendix 1.16 Parameter of Rigid Tapping
#7 #6 #5 #4 #3 #2 #1 #0
5200 SRS FHD PCP DOV CRG G84
『
Modification authority
』
:Equipment management
『
Default Setting
』
: 0000 0000
#0 G84 Method of commanding the rigid tapping
0: M code commands the rigid tapping before command G84/G88 (refer to parameter NO.5210).
1: M code doesn’t command the rigid tapping. G84/G88 is taken as G code of the rigid tapping,
and the common tapping is not used.
#2 CRG After the command of canceling the rigid tapping method, rigid tapping:
0: After the rigid tapping signal RGTAP changes to 0, the method is canceled.
1: Before the rigid tapping signal RGTAP changes to 0, the method is canceled.
#4 DOV Override during the rigid tapping run-out, in the tapping rigid, the override for drawing