Chapter 2 G Commands
135
Ⅰ
Programming
Fig. 2-80
Note 1: Even if the chamfering (, C) or corning R(,R) is specified in other blocks besides G01 and G02/G03
(except for G32, G34), it is ignored.
Note 2: The block following chamfering or corning R for the chamfering or corning operation must be the one
of G01 or G02/G03. The alarm “no movement after chamfering/corning R” occurs when other codes
are specified.
But, only one G04 (dwell) block can be inserted between these blocks. The system pauses after the
inserted chamfering/corning R block is executed.
Note 3: When the system exceeds the previous interpolation movement range caused by the inserted
chamfering or corning R block, the alarm “executed movement being excessive small in the block
following chamfering/corning R” occurs.
Fig. 2-81
Note 4: The chamfering or corning R block can be inserted into the movement codes included in the same
plane.
When the plane selection (G17, G18, G19) in the next block after the chamfering or corning R is
specified, the alarm occurs “the plane selection code is specified after chamfering or corning R”.
Note 5: When two linear interpolation operations are executed and their angle difference is within ±1, the
Block of inserted chamfering R
Arc center of corner R
Block to insert chamfering
Full line is tool
paths without
chamfering
Summary of Contents for GSK988TA
