GSK GSK988TA, Manual

Page: 511 / 531

Appendix 4 Alarm Troubleshooting
493
Appendix
Alarm
No.
Meaning Possible Alarm Reason Troubleshooting
6348
Illegal argument
The argument is incorrect, or the
argument is illegal
Modify the program
6349
Operand of logical
operation statement
error Operand of logical operation
statement OR, XOR, AND are
negative.
Modify the program
6350
G67 custom macro
cancel
G67 was commanded while
corresponding G66 command
was not found. Please check the
program whether G66 should be
added, and referring to para
6000#1 G67.
Modify the program
6351
Macro variables are
protected The macro variable is protected
from modification
Modify the program
6352
Macro variables
modification is
forbidden
The macro value is read-only Modify the program
6353
Overflow of float
data
Float data exceeds the allowed
range in macro
calculating(±1E47 when
ARA.6008#0 is set to 1, or else is
±1E308)
Please modify the program
or PARA. 6008#0
6354
Macro prog.
shouldn't be called
by M code
Macro prog. shouldn't be called
by M code
Modify the program
6355
Null value not
allowed for system
macro
Null value is not allowed to set to
system macro
Modify the program
6356
Not proper T code
to call custom
macro program
Not proper T code to call custom
macro program
Modify the program, or refer
to Para.No.6008#5,
6060~6069
6357
Illegal G code in
same block with
G66/G67 G66/G67 doesn't work with G
code of other group in same
block.
Modify the program
6370
No solution at NRC
A point of intersection can't be
determined for tool nose radius
compensation.
Modify the program
6371
Not allowed to start
& cancel NRC in
arc command Start or cancel tool nose radius
compensation in circular
interpolation
Modify the program
6372
Can't change plane
in NRC The offset plane is switched in
tool nose radius compensation
Modify the program
6373
Interference in
circular block
The arc start point or end point
coincides with arc center, or
destination point is not on arc.
Modify the program
6374
Interference in G90
or G94 block
Overcut will occur in tool nose
radius compensation in canned
cycle G90 and G94
Modify the program
6375
Interference in arc
concluded from
checking
Overcut is possible to occur in
tool nose radius compensation
Modify the program
6376
Inconsistent of
direction of tool
path in NRC and on
drawing Inconsistent of direction of tool
path in NRC and on drawing(if
exceeds range between 90 and
270 degree)possibly result in part
Modify the program