GSK GSK988TA, Manual

Page: 395 / 531

Appendix 1 Parameters
377
Appendix
Set the low limit speed (FL speed) of acceleration and deceleration in index type during each axis
JOG feeding.
1626
Time constant of acceleration and deceleration during each axis
thread cutting cycle (TET)
『
Modification authority
』
: Equipment management
『
Parameter Type
』
: Word axis
『 Value Range 』 : 0 ～ 4000ms
『
Default Setting
』
: 100
Set the time constant of acceleration and deceleration in linear and index types during each axis
thread cutting cycle.
1627
FL speed of acceleration and deceleration in index type during
each axis thread cutting cycle (FLT)
『
Modification authority
』
: Equipment management
『
Parameter Type
』
: Word axis
『
Value Range
』
:
VALID RANGE SETTING
UNITS
VALUE
UNITS
IS-B IS-C
DEFAULT
SETTING
Machine in metric
system
1 mm/min 0
，
6
～
15000 0
，
6
～
12000 30
Machine in inch
system
0.1 inch/min 0
，
6
～
12000 0
，
6
～
6000 30
Set low limit speed (FL speed) of acceleration and deceleration in index type during each axis thread
cutting cycle.
1628
The acceleration/deceleration time constant of the end-retraction
motion in the thread cutting cycle along each axis (TST)
『 Modification authority 』 : Equipment management
『
Parameter Type
』：
Word axis
『
Value Range
』：
0
～
4000ms
『
Default Setting
』：
0
Set the acceleration/deceleration time constant of end-retraction short axis when the thread
cutting cycle of each axis is performed; when this parameter setting value is “0”, use the No.1626