GSK GSK988TA, Manual

Page: 128 / 531

GSK988TA/GSK988TA1/GSK988TB Turning Center CNC System User Manual 【 Programming & Operation 】
110
Ⅰ
Programming
Fig. 2-64
Execution process:
(1) The tool rapidly traverses to B
1
, and the thread cutting depth is
△
d. The tool only
traverses in X direction when a=0; the tool traverses in X and Z direction and its direction
is the same that of A
→ D when a ≠ 0;
(2) The tool cuts threads paralleling with C → D to the intersection of D → E (r ≠ 0: thread
run-out);
(3)
The tool rapidly traverses to E point in X direction;
(4) The tool rapidly traverses to A point in Z direction and the single roughing cycle is
completed;
(5) The tool rapidly traverses again to tool infeed to B
n
( is the roughing times), the cutting
depth is the bigger value of (
n
△
× d) ,(
1 n
−
△
× d+
△
d
min
) , and execute
②
if the
cutting depth is less than(k-d) ; if the cutting depth is more than or equal to(k-d) , the tool
infeeds (k-d) to B
f
, and then execute
⑥
to complete the last thread roughing;
(6) The tool cuts threads paralleling with C → D to the intersection of D → E (r ≠ 0: thread
run-out);
(7)
X axis rapidly traverses to E point;
(8) Z axis traverses to A point and the thread roughing cycle is completed to execute the
finishing;
(9)
After the tool rapidly traverses to Be (the cutting depth is k and the cutting travel is d),
execute the thread finishing, at last the tool returns to A point and so the thread finishing
cycle is completed;
(10) If the finishing cycle time is less than m, execute
⑨
to perform the finishing cycle, the
thread cutting depth is k and the cutting travel is 0; if the finishing cycle times is equal to
m, G76 compound thread machining cycle is completed.
Note 1: When G76 is executed, after
【
FEED HOLD
】
key is pressed and the system executes this thread cutting
cycle, the system enters pauses state and “Stop” appears in the status column;
Note 2: The single block is executed during the course of thread cutting, the run stops after the system
returns to start point (one thread cutting cycle is completed);
Note 3: The thread cutting speed stops when the system resets, emergently stops or the drive until alarms;