GSK GSK988TA, Manual

Page: 59 / 531

Chapter 2 G Commands
41
Ⅰ
Programming
Note 4: P, X, U are in the same block, P is valid; X, U are in the same block, the later specified code is
valid.
Note 5: The dwell can be executed after the current delay time is completed in executing the feed hold in
G04.
Note 6: When G04 and subprogram M98 /M99 P__ are in the same block, the number following P is the
time value of G04 dwell, and is also the message of M98/M99, i.e. subprogram skip message
error.
Note 7: G04 and the interpolation code in Group 1(such as G00, G01) are in the same block, G04 is valid,
G0, G01 only change the modal value of G codes in Group 1.
Note 8: When No.3403 Bit 6(AD2) is 0, G04 and G codes in Group 00 are in the same block, and the later
specified code is valid.
2.7 Cylindrical Interpolation 7.1
Command function: the cylindrical interpolation is defined that the movement amount of rotary
axis specified by angle is converted into the movement distance of linear
axis along the surface in the CNC inside, which makes the rotary axis and
other axis execute the linear interpolation or circular interpolation. After
interpolation, the distance is converted into the movement amount of the
rotary axis, which is shown below:
Fig. 2-9
Command format
：
r
C
B
A
Z(W)
Y(V)
X(U)
G07.1
⎪
⎪
⎪
⎪
⎭
⎪⎪
⎪
⎪
⎬
⎫
⎪
⎪
⎪
⎪
⎩
⎪⎪
⎪
⎪
⎨
⎧
； Activate the cylindrical interpolation code. G07.1 can be written to G107 or
G7.1, but must not be with other code in a line;
…… ；
……
；
Developed