GSK GSK988TA, Manual

Page: 417 / 531

Appendix 1 Parameters
399
Appendix
0
：
Keep
1 ： Clear
#2 CSB Whether the coordinate system is automatically set up when CS outline control
shifts to the position mode
0
：
Disabled
1 ： Enabled
#7 #6 #5 #4 #3 #2 #1 #0
3703 MPP
『
Modification authority
』
: Equipment management
『
Default Setting
』：
0000 0000
#3 MPP Whether replaces the signal SWS to perform the spindle selection by program
command in the multi-axis control.
0
：
NO
1
：
YES
#7 #6 #5 #4 #3 #2 #1 #0
3704 SCS3 SCS2
『 Modification authority 』 : Machine
『
Validate method
』
: After power-on
『
Default Setting
』：
0000 0000
#6 SCS2 Whether Cs contour control of the 2nd spindle is
0: Invalid
1: Valid
#7 SCS3 Whether Cs contour control of the 3rd spindle is
0: Invalid
1: Valid
#7 #6 #5 #4 #3 #2 #1 #0
3705 EVS
『 Modification authority 』 : Equipment management
『
Default Setting
』：
0000 0000
#4 EVS For S command, use spindle control function (spindle analog output or spindle serial
output)
Note: Parameters SCS2 and SCS3 can be enabled by using the Cs outline control
(that is, bit 2 of parameter No.8133 (SCS) is “1”)