GSK GSK988TA, Manual

Page: 452 / 531

GSK988TA/GSK988TA1/GSK988TB Turning Center CNC System User Manual 【 Programming & Operation 】
434
Appendix
value based upon the T code numerical value becomes the tool group number of the tool life-span
administration.
6811 The M code is used by tool life-span counting restart (MRN)
『
Default Setting
』：
0
『
Modification authority
』
: Equipment management
『
Value Range
』：
0
～
127
『 Validate method 』： Immediately
In this case, the life-span existence is set by times, the tool group when the tool life-span
counting restarting specifies the M code is used up.
The tool-change signal (TLCH) may also be output even if only one signal; when it is set to 0, the
parameter will then be ignored.
6813 The Max. group number of the tool life-span administration (MTN)
『
Default Setting
』：
0
『
Modification authority
』
: Equipment management
『
Value Range
』：
0, 8, 16, 32, 64, 128
『 Validate method 』 : After power-on
Set the used top group number of each path, after this parameter is set, the power should be
temporarily turned off.
6844 The residual span using times of tool (TLP)
『
Default Setting
』：
0
『 Modification authority 』 : Equipment management
『
Value Range
』：
0~65535
『
Validate method
』：
Immediately
In the case of the tool life-span is specified, cutter output span reaches to the tool residual span
of the predictive signal (Using times).
6845 The remainder span using time of tool (TLR)
『
Default Setting
』：
0
『
Modification authority
』
: Equipment management
『
Value Range
』：
0~4300
『 Validate method 』： Immediately
In the case of the tool life-span is specified, cutter output span reaches to the tool residual span