GSK GSK988TA, Manual

Page: 434 / 531

GSK988TA/GSK988TA1/GSK988TB Turning Center CNC System User Manual 【 Programming & Operation 】
416
Appendix
5115
The clearance value of peck drilling cycle
（
PDCRD
）
『
Modification authority
』
: Equipment management
『 Value Range 』： 0 ～ 99 999 999× （ system limit increase ）
『
Default Setting
』：
1000
The clearance value of G83, G87 peck drilling cycle is set by the parameter.
Appendix 1.15.2 Parameter of Thread Cutting Cycle
5130 Chamfering value of the thread cutting cycle
（
G76
，
G92
）
(THD)
『
Modification authority
』
:Equipment management
『
Value Range
』
: 0
～
99× (0.1 screw pitch)
『 Default Setting 』 : 0
The parameter sets the beveling value of G76 and G92 thread cutting cycle.
5131 Chamfering angle in threading cycle(G92, G76) (CAT)
『
Modification authority
』
:Equipment management
『
Value range
』
:0
～
89
『 Default 』 :0
The chamfering angle in threading cycle (G76) of the multiple repetitive canned cycle and the
thread cutting cycle (G92) of single canned cycle are set by the parameter. When the parameter is
set to 0, a value of 45 degree is determined.
Appendix 1.15.3 Parameter of Thread Cutting Cycle
5132 Cutting value of the combined canned cycle G71 and G72 (THC)
『
Modification authority
』
:Equipment management
『 Value Range 』 : 1 ～ 99 999 999
『
Default Setting
』
: 1000
Set the cutting value of G71 and G72 combined canned cycle.
5133 Tool retraction amount of G71 and G72 combined canned cycle (MCE)
『
Modification authority
』
:Equipment management
『 Value Range 』 : 0 ～ 99 999 999
『
Default Setting
』
: 0
Set the run-out value of G71 and G72 combined canned cycle.