GSK GSK988TA, Manual

Page: 429 / 531

Appendix 1 Parameters
411
Appendix
#5 CNF When the tool nose radius compensation is interference checked, whether alarm
when the internal full circle is cut
0: P/S alarms
1: Not alarm
#6 CNS The tool nose radius compensation is interference checked, whether alarm when
the step is less than the tool radius
0: P/S alarms
1: Not alarm
#7 #6 #5 #4 #3 #2 #1 #0
5009 TSD GSC
『 Modification authority 』 : Equipment management
『
Default Setting
』
: 0000 0000
#0 GSC The tool compensation measure value is directly input the offset write input signal
in function B
0 ： It inputs from one side of machinery
1
：
It inputs from one side of PLC
#4 TSD The tool compensation measure value is directly input in function B, so that the
movement direction distinguish specification is:
0 ： Disabled
1
：
Enabled
5010
During the tool nose compensation, the limit value of the vector is
ignored when the tool traverses along the corner outside (CLV)
『
Modification authority
』
: Equipment management
『 Value Range 』 : 0 ～ 16383
SETTING UNITS IS-B IS-C UNITS
Input in metric system 0.001 0.0001 mm
Input in inch system 0.0001 0.00001 inch
『
Default Setting
』
: 0
The limit value of the minor traverse value is ignored when the tool nose radius compensation is
set and the tool traverses along the corner outside.