GSK GSK988TA, Manual

Page: 405 / 531

Appendix 1 Parameters
387
Appendix
#0 GWC Whether the gateway data uses the CRC verification
0 ： Disabled
1
：
Enabled
#1 GWP Whether the gate data uses the communication agreement
0
：
Disabled
1 ： Enabled
Appendix 1.10 Parameter of Display and Editing
#7 #6 #5 #4 #3 #2 #1 #0
3101 BGD
『
Modification authority
』
: Equipment management
『
Default Setting
』
: 0000 0000
#4 BGD Background editing selects the programs selected at the foreground
0: Editable
1: Unedited
#7 #6 #5 #4 #3 #2 #1 #0
3104 DAC DAL DRC DRL MCN
『
Modification authority
』
:Machine
『
Default Setting
』
: 1100 0000
#0 MCN Display the machine position
0: Display based on the output units
(There isn’t any connection with the metric system or the inch system, the metric
machine displays as the metric units, the inch machine displays as the inch units.)
1: Display based on the input units
(When it is input in the metric system, display in the metric system; when it is input in the
inch system, display in the inch system)
#4 DRL Display the relative position
0: Display the actual position including the tool offset (T serial)
1: Display the programming position without the tool offset (T serial)
Note: In T serial, the movement coordinate system compensates the tool appearance, (parameter LGT
(NO.5002#4) is 0), display the programming position which ignores the tool compensation (the
parameter is set as 1). However, the programming position without the tool appearance
compensation value can not display.
#5 DRC Display the relative position
0: Display the actual position including the tool nose radius compensation (T serial)