GSK GSK988TA, Manual

Page: 282 / 531

GSK988TA/GSK988TA1/GSK988TB Turning Center CNC System User Manual 【 Programming & Operation 】
264
Ⅱ
Operation
3.4.2.2 Coordinate Setting
Press function key to enter the setting page set; On CNC setting page, press
software key to enter the coordinate setting page, which is shown in Fig.3-43:
Fig.3-43
On the coordinate setting page, the origin offset amount of each axis and the offset value of each
coordinate axis in each coordinate system are displayed, the origin offset amount corresponding to
each axis and the offset value of each coordinate axis of each coordinate system can be set.
On the coordinate setting page, the coordinate system to be set is selected by the up/down keys
, , and the coordinate axis to set the offset is selected by left/right keys , ,
there are three methods of rewriting the tool offset: Direct inputting, measuring inputting and +
inputting:
Direct inputting: Select the coordinate axis to be rewritten, press key, and then input
the offset value, and then confirm.
Measuring inputting: Select the coordinate system to be rewritten, press to
input the measured value (if it is X axis, input X--; Z axis, input Z---), and then confirm.
+input: Rewrite the input offset value, and it is the incremental input. For example, in G54
coordinate system, X axis needs to be added up the offset value of –0.2mm, firstly, move the cursor to
X axis position in G54 coordinate system, and then press
，
and input –0.2, and
–0.2mm is added into the current offset value after confirming.
On the right column of the page, the current absolute position coordinate value and the relative
one, and the tool number used by the current program, etc are displayed meanwhile.
Note 1: The coordinate offset can be set or rewritten only when the parameter switch is ON and in MDI
modal and the operation authority is equal to or higher than level [4].