GSK GSK988TA, Manual

Page: 418 / 531

GSK988TA/GSK988TA1/GSK988TB Turning Center CNC System User Manual 【 Programming & Operation 】
400
Appendix
0: Not output S code and SF
1: Output S code and SF
#7 #6 #5 #4 #3 #2 #1 #0
3706 MPA
『
Modification authority
』
: Equipment management
『
Default Setting
』：
0000 0000
#2 MPA In the multi-spindle control, when the spindle selection of the address P is set, and
when the P does not specify with the S command:
0
：
Alarm issues
（
PS5303
）
1
：
Use the last P specified by S_ P_;. After the power is turned on, use the value of parameter
( № 3775) when never ever specifies the P.
#7 #6 #5 #4 #3 #2 #1 #0
3708 TSO SSC SAT SAR
『
Modification authority
』
: Equipment management
『
Default Setting
』
: 0000 0011
#0 SAR Whether check the spindle speed reaching signal
0: Not check
1: Check
#1 SAT Whether check the spindle speed reaching signal when the thread cutting block is
begun to be executed.
0: Check or not, which is set by parameter SAR (NO.3708#0)
1: Must check, which isn’t connected with parameter SAR
Note: When the thread cutting block is continuously executed, the spindle speed reaching signal
isn’t checked in the thread cutting block after the 2
nd
block.
#2 SSC Whether check the spindle speed when performs the cutting feed
0
：
Do not check
1
：
Check
#6 TSO Whether the spindle override is valid during thread processing or tapping cycle
0: Invalid (fixed as 100%)
1: Valid
Note: In rigid tapping, the override is fixed as 100%, and there isn’t any connection with the
setting of the parameter.
#7 #6 #5 #4 #3 #2 #1 #0
3709 MSI SAM