GRAUPNER mx-20 Hott, Programming Manual

Page: 25 / 296

25 Transmitter description - Display and keypad
Operating the "data terminal"
Entry keys ESC and SET
Display symbols
Displayed telemetry symbols
the active model memory has not yet "bonded"
with a HoTT receiver. More about the "Binding"
process, see page 69 or 75.
non-blinking: Switched off on RF transmitter side
blinking antenna symbol:
The last receiver bound to the active model is
inactive or out of range
>
M
x no telemetry signal to receive
> M signal strength indicator
> P indicator for pupil signal strength on the teacher
transmitter display
Keys left of the display
ESC • key
brief repeated pressing the ESC key will cause a
stepwise return to the function selection screen or
even further to the base screen. Any changes made
to settings remain.
Momentarily touching the
ESC key for about 1 s
while in the base screen will open and close the
Telemetry menu.
arrow keys
•
 
Momentarily pressing one of these keys will cause 1.
analogous paging in the given arrow direction
through lists, e. g. through the model selection list
or the multi-function list or within menus though
the menu's lines.
Simultaneous pressing on
2.

will change the
transmitter's base screen and almost any menu
position to the "
Servo display " menu.
Keys to the right of the display
SET • button
After switching the transmitter on, briefl y pressing 1.
the SET key will cause a jump from the displayed
base screen to the Multi-function menu. In the
same manner a selected menu can now be called
up with the
SET key.
Momentarily pressing the 2. SET key from within
the Basic Settings menu will activate / deactivate
(confi rm) the given setting fi elds.
arrow keys •
 
1. "Paging" through the Multi-function menu and
the menu lines within the Basic Settings menu
analogous to the arrow keys of the left touch pad.
2. Select or set parameters in setting fi elds after they
have been activated by briefl y touching the SET
key, whereby the

keys and

are used for
the same corresponding functions. In this case it
is completely irrelevant which of these two keys
are used.
By briefl y pressing the
3.

keys simultaneously
or

an altered parameter value for the active
entry fi eld will again be restored to its default
value (
CLEAR) .
Notice:
Touching the given touch pad does not itself initiate •
the given action but rather the end of the touch.
In the event the touch pads do not exhibit any
•
functionality immediately after switching the
transmitter off and then on again right away, this is
not a fault. Just switch the transmitter off again then
wait for several seconds before switching it on again.