GRAUPNER mx-20 Hott, Programming Manual

Page: 219 / 296

219 Detail program description - Control adjust
remains controllable when the SUMO satellite
receiver no longer receives a signal.
Telemetry data, such as the voltage of the onboard
electricity supply, on the other hand, is only sent to
the transmitter by the satellite receiver confi gured
as SUMO. Therefore, telemetry sensors are to be
connected to the satellite receiver (SUMO).
Each receiver should be connected with its own
supply line from the common voltage supply. With
receivers with a high current load, it may even be
benefi cial to connect them with two supply lines to
the same current supply.
On the other hand, if each of the two receivers
should be supplied from
its own voltage source,
the center cable must
be removed from one of
the two plugs of the sat-
ellite cable; see fi gure.
red
1
2
3
If you would like to carry out additional programming,
such as fail-safe settings, disconnect the three-
pole satellite connection between the two receivers
and switch on only the relevant receiver. It may be
necessary to also change the connection sequence.