GRAUPNER mx-20 Hott, Programming Manual

Page: 130 / 296

130 Detail program description - Control adjust
Using the arrow key

on the left or right touch pad,
move the marker frame over the "ph. Tim." column – and
"Motor" column, if applicable – to the right.
Pha1
Pha2
Pha3
Name Sw.time
Pha4
Pha5

+
+
Nor mal
Launch
Dist.
–
–
0.1s
0.1s
0.1s
0.1s
0.1s
Briefl y tap the center SET key on the right touch pad to
highlight the value fi eld. You can then select switch times
between 0 and 9.9 s in this fi eld.
Example:
Pha1
Pha2
Pha3
Name
Pha4
Pha5

+
+
–
– 3.0s
2.0s
4.0s
0.1s
0.1s
Sw.time
Nor mal
Launch
Dist.
The switch time is set to 4.0 s when switching from any
phase to Phase 1 "Normal".
When switching from e. g. Phase 1 to Phase 3, the
switch time is set to 2.0 s and to 3.0 s when switching
from Phase 1 or 3 to Phase 2 "Launch".
Such asymmetric transition times can be useful when
(e. g.) switching between highly contrasting fl ight phases,
such as e. g. between aerobatics and normal fl ight.
Tapping the

or

keys on the right touch pad at
the same time ( CLEAR ) will reset the time to 0.1 in the
active value fi eld.
Note:
The "switch time" set here applies uniformly to all
settings that are specifi c to fl ight phases, and thus to
all mixers activated in the "
Wing mixers " menu (see
page 146). Accordingly, the transition between fl ight
phase-specifi c mixers does not occur abruptly. If you
want individual servos to be switched without a delay,
however, defi ne these accordingly in the "
Non-delayed
channels " menu (see page 137).