B&R Industries X20 System, User Manual

Page: 1463 / 2720

X20 system modules • X20 electronics module communication • X20CS1011
X20 system User's Manual 3.10 1463
Product ID X20CS1011
Environmental conditions
Temperature
Operation
Horizontal installation 0 to 55°C
Vertical installation 0 to 50°C
Derating -
Storage -25 to 70°C
Transport -25 to 70°C
Relative humidity
Operation 5 to 95%, non-condensing
Storage 5 to 95%, non-condensing
Transport 5 to 95%, non-condensing
Mechanical characteristics
Note Order SmartWire attachment cable X20CA4S00.00xx separately
Order 1x X20BM11 bus module separately
Spacing 12.5
+0.2
mm
Table 452: X20CS1011 - Technical data
1) Using an external feed makes it possible to shut down via E-stop or switching relay
4.18.2.4 LED status indicators
For a description of the various operating modes, see the 2.11.1 "re LEDs" section.
Figure LED Color Status Description
Off No power to module
Single flash RESET mode
Blinking PREOPERATIONAL mode
r Green
On RUN mode
Off No power to module or everything OK
On Error or reset status
e Red
Single flash Warning/Error on an I/O channel
e + r Red on / Green single flash Invalid firmware
S + R Green The "S" and "R" LEDs indicate the status of the SmartWire interface.
Off U-Aux supply missing or too low A Green
On U-Aux supply OK
"S" and "R" LEDs
The status of the SmartWire interface is indicated by the "S" and "R" LEDs.
S R Firmware status Description
CHECK_INT_FRAM Initialization
CHECK_LIN_SUPPLY Wait until 17 VDC bus is OK
Off Off
INT_ERROR_STATE Internal error has occurred (remains)
SET_TRANSCEIVER_MODE Initialization of transceiver
RESET_UART
Initialization of UART + 10 ms delay
Off On
READ_REVISION_CNT Initialization (revision counter from FLASH)
INIT_LIN_SCAN Initialization for bus scan
RUN_LIN_SCAN Perform bus scan
INIT_LIN_SETUP Initialization for RUN_LIN_SETUP
RUN_LIN_SETUP Perform bus setup
STORE_REVISION_CNT Revision counter in FLASH
Blinking slowly Blinking slowly
WAIT_FOR_PUSHBUTTON Wait for configuration button after bus scan and difference with existing config-
uration
Blinking slowly Blinking quickly TIME_DELAY 4 s optical confirmation signal after pressing the configuration button
DP_CFG_CHECK Check of the configuration by the higher-level CPU (not currently used)
SET_SLAVES_TO_OP Switch SmartWire stack to Operational
SET_SLAVES_TO_PREOP Switch SmartWire stack to Preoperational
INIT_LIN_SCHED Initialization for RUN_LIN_SCHED
On Blinking slowly
RUN_LIN_SCHED (PREOP) RUN SmartWire scheduler (in PREOP)
On On RUN_LIN_SCHED (OP) RUN SmartWire scheduler (in OP)
Blinking slowly On IDLE_STATE RUN SmartWire without scheduler (no slaves connected)
Blinking quickly On LIN_ERROR_STATE ERROR LIN-BUS has occurred (remains)