ASP STERRAD 100, Service Manual

Page: 208 / 309

4
Note
: If the used pump oil is excessively dirty, flush out the
pump according to the Vacuum Pump Flush procedure
4. Open a new bottle of pump oil and replace the cap with the oil filler
cap (red tipped). Remove the red tip and cut about 1/6 to 1/4 inch
off the cap tip so the oil flows freely.
5. Pour new pump oil (slightly less than one quart) into the oil fill port
until oil reaches the raised line at the top of the sight glass (the MAX
line on the Leybold D16A). DO NOT OVERFILL or attempt to empty
the oil bottle. Some oil may remain in the bottle when the pump oil is
at the specified fill level.
6. Re-cap and dispose of the drained oil and the oil absorbent cloth
following standard hospital procedures.
Drain the Air Storage Tank
The air storage tank is different on Block 2 machines.
1. Using a towel, cover the drain of the air storage tank, then slowly
open the drain cock. On Block 2 systems, press the trigger to fill the
bottle. Than empty the bottle and replace it.
2. When no further water flows from the drain, close the drain cock.
Repeat steps 1 and 2 after 10 seconds. Clean up any areas splashed
with water.
Drain the Air Storage Tank (Block 2)
1. Locate the water collection bottle.
2. Press the air trigger and water flows from the tank into the collection
bottle.
3. Remove the bottle, empty it and replace it.
Drain the Pressure Regulator Moisture
Trap
1. Place a towel below the pressure regulator trap prior to drainage.
2. Press upwards through the towel on the button at the bottom of the
trap and permit water to escape.
Level 1 Planned Maintenance Planned Maintenance
ASP Service Guide rev. D STERRAD® 100 Sterilizer 12-5