ASP STERRAD 100, Service Manual

Page: 127 / 309

4. Press
OPEN DOOR
until a 6 is displayed. (The numbers in the other
fields are not important for this procedure.)
5. Press
OPEN DOOR
once more and the system resets to 0. The serial
number is also reset at this time.
6. Press
OPEN DOOR
enough times to change the first digit of the
machine cycles back to the number noted in Step 1.
7. Press
CLOSE DOOR
to move the cursor to the left. Press
OPEN
DOOR
to set the next digit. Continue pressing
CLOSE DOOR
to
move the cursor and
OPEN DOOR
to set the digits to correspond to
the machine cycles noted in Step 1.
8. Press
CANCEL
to change the fields. The Clock Mode is displayed.
Setting the Clock Mode-STERRAD 100 S Systems
1. Press CANCEL to display the following
CLOCK MODE XX
OPEN(chng)-CLOSE(accept)
XX is the mode of the clock (12 hour time or 24 hour time).
2. Press OPEN to toggle the clock mode to a desired setting. This
setting affects all printed time notations.
3. Press
CLOSE
or
CANCEL
to go to the Cycle Type menu. If you not
setting the cycle type, press CANCEL twice to enter the Serial
Number Menu
Setting the Serial Number- STERRAD 100 S Systems
The serial number menu looks like this:
SERIAL NUMBER XXXXXX
OPEN(chng) - CLOSE(accept)
XXXXXX represents the machine serial number; it can be any
number from 0 through 999999.
1. Press
OPEN DOOR
enough times to change the first digit of the serial
number.
2. Press
CLOSE DOOR
to move the cursor to the left. Press
OPEN
DOOR to set the next digit. Continue pressing CLOSE DOOR to
move the cursor and
OPEN DOOR
to set the digits to correspond to
the machine serial number located on the frame behind the storage
drawer.
3. When you have set the serial number, press CLOSE DOO R so that
you do not accidentally change the number.
User Interface and Control Subsystems User Interface Calibration
6-14 STERRAD® 100 Sterilizer ASP Service Guide rev D.