ASP STERRAD 100, Service Manual

Page: 147 / 309

3. Adjust the speed control valve to close the door in approximately 5
seconds. Secure the locking nut.
4. Loosen the speed control valve locking nut on the control valve
located on the exhaust (upper) side of the door cylinder.
5. Adjust the speed control valve to open the door in approximately five
seconds. Secure the locking nut.
Door Open and Close Speed (Block 2)
1. Remove the system panels. Verify that the air pressure is set to cut-in
at 60 PSI and to cut-out at 80 PSI.
2. Adjust the speed control valves on the valve assembly to fully open
(counterclockwise). Then close them 3 full turns.
3. Operate the door to verify sealing of the chamber face.
4. Adjust the door open and close speeds with the speed control valves
to that the door closes in approximately 5 seconds.
Door and Chamber Alignment
Following are a number of procedures for aligning the chamber, frame,
and door. Start with the first three steps here regardless of the
alignment you are going to perform.
1. Remove the system panels. Open the paper storage drawer and find
the service position lever. Lower the door to the service position.
2. Remove the chamber door O-ring.
3. Remove electrical power from the system. Mark the position of both
air lines to the door cylinder and then disconnect.
Align Frame to Right Guide Rail
1. Loosen, do not remove, all hardware securing right guide rail to frame
and chamber.
2. Using gage T.2270 align the frame to the right guide rail by adjusting
upper edge of guide rail at top panel bracket. See the diagram.
3. Tighten all hardware securing the right guide rail to the frame,
leaving the chamber hardware loose.
Calibration Door and Chamber Subsystem
ASP Service Guide rev D STERRAD® 100 Sterilizer 7-7