ASP STERRAD 100, Service Manual

Page: 191 / 309

Installing the Seismic Restraints
This procedure is for both Block 1.8 and
Block 2
STERRAD 100
Sterilizers since the restraints can be used with either system type. This
procedure is approved by the State of California Building Code as a valid
seismic restraint procedure.
The Seismic Restraint installation kit contains:
F
two brackets
F
two subframe pieces (these are extension pieces used to build up the
frame on Block 1.8 systems)
F
attachment hardware
F
drilling template
The kit should be ordered from Customer Service and the installation
coordinated by ASP Technical Services.
Pre-Installation Procedure-To Be Done
by the Customer
The customer must identify the location for the STERRAD 100 Sterilizer
and perform steps 1-4 below prior to any other installation procedures.
4 4
Note: There is a drilling template included in the kit. It has
the proper dimensions and drilling positions.
1. Position the rear bracket on the floor about 2 inches away from the
wall (1-1/16 inches minimum) and mark the location of the holes for
drilling. If there is an outlet in the wall at the desired installation
location, add at least 3 inches to the distance.
2. Using the dimensions in the diagram below, and in the kit diagrams,
measure carefully and position the front bracket on the floor (about
33 inches from the rear bracket). Mark the location of the holes for
drilling.
3. Drill 12 each, 3/8 inch holes in the floor. (Use the manufacturer’s
recommendation for the anchor bolts if the size is different than 3/8
inch.)
4 4
Note: Use only approved anchor bolts shown in the table.
(S=standard steel, SS=stainless steel).
Installing the Seismic Restraints System Installation
ASP Service Guide rev. D STERRAD® 100 Sterilizer 11-9