ASP STERRAD 100, Service Manual, Page: 200 / 309

Power Plug
1. If not already installed, install a plug to the power cord for the correct
voltage for your country. Connect as shown in the table below.
Wire Number Color and Number P80-Connect
1 Black 1 P80-X
2 Black 2 P80-Y
3 Black 3 P80-Z
4 Black 4 P80-W
5 Green/Yellow P80-Ground
Control Panel Bezel
1. Remove the plastic cover from the INSIDE of the clear plastic window.
DO NOT remove the outer protective plastic overlay.
2. Press the control bezel into place on the front of the control panel
until pins lock in the detents and the panel is flush with the front
surface of bezel.
Software Installation
CAUTION: You MUST WORK AT A STATIC PROTECTED
WORKSTATION, BE GROUNDED AT ALL TIMES, AND
CONFORM TO ELECTROSTATIC CONTROL
PROCEDURES. A WRIST STRAP CONNECTED TO
THE FRAME OF THE MACHINE IS NOT GROUNDED
UNLESS THE MACHINE IS PLUGGED INTO AN
EARTH GROUND.
1. Verify that the main circuit breakers are OFF.
2. Plug the machine to a grounded receptacle.
3. If you are setting up the system to operate in a language other than
English, remove the microprocessor board, remove the EPROM and
replace it with the appropriate language EPROM. Note the checksum
listed on the EPROM. Place the removed EPROM in a static safe area.
CAUTION! Pay particular attention to the orientation of the
EPROM during insertion into its IC socket.
Additionally, exercise care to ensure that the
EPROM pins are not bent, broken, or otherwise
damaged during insertion.
System Installation International System Configurations
11-18 STERRAD® 100 Sterilizer ASP Service Guide rev. D