ASP STERRAD 100, Service Manual, Page: 14 / 309

Section Differences Notes
Injection Subsystem
Injector valve height calibration has a
new procedure.
Injector pump valve can now be
adjusted.
All Block 1.8 systems require an
upgraded injection system to support
the STERRAD 100 S Software. Some
Block 1.8 systems have the upgraded
injection system regardless of the type
of software used.
Change from rev C
Door and chamber
subsystems
Door and chamber thermocouples are
in a different location and are tested in
a different manner.
NEW!
Removal and replacement of the door
and feedthrough are augmented in the
on-line guide with video clips.
Guide rail alignments have changed.
Door open/close speed setting have a
new procedure.
The door solenoid features a safety
lock.
Change from rev C
Controller Subsystem Pin connectors on control panel are
different and in different locations.
Analog to digital set point test points
are in a different location.
Analog to digital set point test point
are in a different location.
Microprocessor PCB is different
All STERRAD 100 S Systems have a
Z180 CPU.
Change from rev C
AC subsystem
AC circuit breakers are on the exterior
of the system in
Block 2
.
User Interface
The
Block 2
membrane switch has
different removal procedure.
What’s New in this Guide? About the Service Guide
ASP Service Guide rev. D STERRAD® 100 Sterilizer 1-5