ASP STERRAD 100, Service Manual, Page: 218 / 309

Introduction
This section contains the procedures necessary to certify system
performance of the STERRAD® 100 Sterilizer and the STERRAD 100 S
Sterilizer. Product Certification is an important procedure that should
follow various activities performed in the field regarding the sterilization
system. If the certification procedures indicate that adjustment is
needed, you should perform the adjustments according to the specific
calibration procedures shown in this guide.
Some of the activities requiring certification are:
F
Planned Maintenance
-Verify system performance following both
PM1 and PM2 services. Be sure to complete the appropriate field
service reports.
F
Installation
-Verify system performance following uncrating, set-up,
and initial system operation.
F
Removal and Replacement
-Verify system performance following
removal and replacement of subsystems. The Product Certification
may only need to be done to the particular subsystem replaced.
F
Routine Inspection
-Verify system performance as part of the
routine inspection associated with the ALLIANCE(SM) Service
Program contracts. Be sure to complete the appropriate field service
reports.
Remember: when you see the STERRAD icon, it means that the
procedure, or steps within the procedure being described are for a
different configuration of the subsystem or part. The configuration
differences are for
Block 2
and STERRAD
100 S
Systems. It is
important to note that Block 1.8 systems can be upgraded to run the
STERRAD 100 S Software. If that has been done, perform the Block 1.8
tests unless the instructions indicate to do otherwise.
Also note, some parts in the field pre-date standard Block 1.8 devices
described in the “About this Guide” section. Be sure you use the correct
procedure for the equipment you are servicing.
Product Certification Introduction
13-2 STERRAD® 100 Sterilizer ASP Service Guide rev. D