ASP STERRAD 100, Service Manual, Page: 215 / 309

Door and Chamber Procedures
Cleaning the door and process chamber requires a number of steps
including the removal of the RF electrode. The rear of the door should
be cleaned during PM 1 and the chamber and electrode examined and
cleaned if necessary during that PM.
PM2 procedures require that the electrode be removed and it and the
chamber thoroughly cleaned. During PM2 the door seal O-ring must be
replaced. It should be inspected and cleaned as needed during PM1.
The following three procedures, “Replace Door O-Ring Seal,” “Clean Door
Surface Assembly,” and “Clean Chamber Assembly,” require that the
front and top panels be removed and the door be moved to its service
position.
The procedures listed below appear in the chapter detailing door
procedures.
F
693Opening the Door for Servicing
F
693Replacing the Door Seal O-Ring
F
693Door and Chamber Assembly Maintenance
Upon completion of the chamber cleaning and reassembling the
electrode and spacers, perform the steps below.
4 4
Note: Prior to tightening the screws on the front panels on a
Block 1.8 system, verify the alignment of the cassette
through the cassette door by inserting a cassette.
1. Reinstall the panels and reconnect the cassette door assembly cable.
2. Return the door to the normal position. Clean the rear surface of the
door with deionized water.
3. Close the chamber door. Close the storage drawer.
Clean Platen Surface
1. Clean the surface of the injector pump platen with deionized water
and a lint free cloth.
Planned Maintenance Level 2 Planned Maintenance
12-12 STERRAD® 100 Sterilizer ASP Service Guide rev. D