ASP STERRAD 100, Service Manual, Page: 207 / 309

Level 1 Planned Maintenance
Seismic Restraint Inspection
1. Disengage the system from the brackets, then move it out of the way.
Make sure the bolts are tight, the brackets are in good shape, the
flooring has not cracked or crumbled around the bolts. In the video,
the demonstrator indicates all the points on the brackets that should
be inspected.
2. If there is any problem, even if the brackets are only slightly loose,
contact the proper facilities maintenance personnel at the customer
site and make sure the brackets are properly tightened.
CAUTION: DO NOT replace the system back on the brackets if
they are not tight.
Clean the Vaporizer Plate and Vaporizer
1. Remove the vaporizer plate from the electrode.
2. Inspect it for wear and replace if necessary.
3. Rinse it off and dry it thoroughly.
4. Wipe off the vaporizer bowl and install the vaporizer plate.
Replace Vacuum Pump Oil
4
Note: Always change the pump oil while the pump is warm to
prevent condensation in the pump.
1. Using an 8 mm Allen wrench, unscrew and remove the oil fill plug
located at the top of the pump.
2. Remove the cap from the empty bottle in the kit. Place an oil
absorbing cloth on the floor inside the machine as close to the drain
valve hose as possible. Place the bottle on the cloth. Open the drain
valve, place the hose in the bottle and drain the oil.
When draining oil from a Leybold D16A pump, insert the funnel in the
empty bottle and place it on an oil absorbent cloth, under the valve at
the rear of the pump. Open the valve to drain the oil.
3. After the flow has stopped, close the drain valve. Make sure the main
circuit breaker is off before proceeding.
Planned Maintenance Level 1 Planned Maintenance
12-4 STERRAD® 100 Sterilizer ASP Service Guide rev. D