ASP STERRAD 100, Service Manual, Page: 196 / 309

SERIAL NUMBER XXXXX
OPEN (change) - CLOSE (accept)
4 4
Note:
The serial number is located on the frame behind the
storage drawer.
7. Press CANCEL and the system displays the serial number as follows:
8. A flashing cursor is displayed on the serial number field. To enter the
serial number, press and hold
OPEN DOOR
until the desired number
is selected. Alternate between the field numbers by pressing the
CLOSE DOOR
switch.
9. Simultaneously press
START
and
OPEN DOOR
(the display switches
to the edit date/time display). Then simultaneously press
START
and
CANCEL
to return to the active display.
Cassette Collector Box
1. Remove the cassette collector box from the box base assembly.
2. Reinstall the collector box after the system has signaled reset by a
single beep tone (approximately 10 seconds).
Date and Time
1. Enter the edit mode by pressing
START
and
CANCEL
at the same
time. The LCD display shows the following:
DATE = DAY, MM/DD/YY
OPEN(change) - CLOSE (accept)
DAY
is a three letter abbreviation for the day of the week e.g., WED;
MM is the month, e.g., 03; DD is the numerical day, e.g., 25; and YY
is the year, e.g., 95. A flashing cursor is displayed on the DAY field.
2. To change the displayed day, press
OPEN DOOR
until the desired
day is selected. When the correct day is displayed, press CLOSE
DOOR
to move to the month MM field.
3. Press
OPEN DOOR
to change the MM, DD, and YY each in turn until
the desired setting is displayed. Press
CLOSE DOOR
each time to
move the cursor to the next field. After the YY is updated, the
following message is displayed on the LCD:
System Installation Preparing The System For Use
11-14 STERRAD® 100 Sterilizer ASP Service Guide rev. D