ASP STERRAD 100, Service Manual

Page: 195 / 309

Initialization
The system must be initialized prior to use. The Master Reset procedures
must be followed in the sequence given to accurately reset all system
variables.
Master Resets
The Master Resets are a series of steps used to initialize the system.
They are also used for troubleshooting various error messages. The
steps are: system reset, system variables reset, cassette collector box
reset, date and time reset, and PM log reset.
System Reset
WARNING! Do not perform the master reset when a cycle is in
progress. Perform only when the system is in the
idle state.
1. Remove any cassettes that may be in the injector pump. Discard
according to accepted procedures.
2. Turn the main circuit breaker ON and perform a system reset by
pressing
CANCEL
for ten seconds at the same time power is applied.
The system sounds a beep tone when this process is completed and
displays the date, software part number, and check sum.
System Variables Reset
1. Enter the edit mode by pressing START and CANCEL at the same
time. The system displays the current date information.
2. Simultaneously press and hold
START
and
OPEN DOOR
for 5
seconds. After 5 seconds, the system displays the system serial
number.
3. Press
CANCEL
switch while in the serial number display. The system
displays the total machine cycles field.
4. Write down the number of
TOTAL MACHINE CYCLES
displayed on
the LCD, then reset the total machine cycles to 0.
5. Return to the active display by simultaneously pressing START and
OPEN DOOR (the display switches to the edit date/time display).
Then simultaneously press START and CANCEL to return to the
active display.
4 4
Note:
The reset is not accomplished until you exit the edit
mode.
6. Reenter the edit mode, as shown above and change the total machine
cycles to the number you wrote down in step 4.
Preparing The System For Use System Installation
ASP Service Guide rev. D STERRAD® 100 Sterilizer 11-13