ASP STERRAD 100, Service Manual, Page: 185 / 309

Uncrating the System
The Accessory Installation Kit consists of two boxes. One is on top of the
unit, the other is inside the cassette chute. The side of the crate that
forms the ramp is marked at the bottom of the crate. Be sure the ramp
and ramp supports are securely positioned before moving the system.
1. Position the crate on a level surface so that the ramp side faces an
open area large enough for the ramp to be extended and the unit
removed..
2. Cut the banding and immediately dispose of it.
3. Using a screwdriver remove the two clips holding the ramp in place.
4 4
Note: The crate panels fit together with a tongue and groove
mechanism. The top must be lifted off the sides and the
sides must be lifted up from the pallet base.
Figure 11-1. Shipping Crate
Uncrating the System System Installation
ASP Service Guide rev. D STERRAD® 100 Sterilizer 11-3