ASP STERRAD 100, Service Manual

Page: 192 / 309

Concrete
Type
Min. fc
(psi)
3/8 “ Anchor Type ICBO
Report #
Min
Embedment
(inches)
Test Loads
Hardrock 2000 Hilti Kwikbolt II (S)
(SS)
4627 1-5/8 Direct Pull
Tension -1100 lbs
Torque 25 ft/lbs
Rawl Stud (S) (SS) 4514 1-5/8
ITW/Ramset
Trubolt (S) (SS)
1372 1-1/2
Wej-It Anchor Bolt
(S)
1821 1-1/2
Lightweight 3000 Hilti Kwik Bolt II
(S) (SS)
4627 1-5/8 Direct Pull
Tension -700 lbs
Torque 10 ft/lbs
ITW/Ramset
Trubolt (S) (SS)
1372 1-11/16
ITW/Ramset
Dynabolt (S) (SS)
1372 1-1/2
4. Using a hammer, drive the anchor bolts into the holes drilled in the
floor. Please allow enough room to mount the bracket, washer and
nut.
Installing the Subframe
4 4
Note: This procedure is not done on Block 2 systems. Skip to
Installing the Brackets
1. Remove the system panels.
2. Attach the anchor pin and the M10 washer onto the front subframe
piece.
3. Lift the unit up on one side and support with a wooden support (a
large roll of paper works well, too.
4. Slide the front subframe piece (the one with the flange) into the
groove on the unit.
5. Slide the rear subframe piece into the rear of the STERRAD 100
Sterilizer frame. Make sure it slides into the hollow track of the frame.
6. Align the rear subframe with the holes used to mount the unit to the
shipping pallet.
7. Fasten the rear subframe to the pallet mounting holes with the M8
screws, flatwashers and lockwashers. The two shorter M8 Allen
System Installation Installing the Seismic Restraints
11-10 STERRAD® 100 Sterilizer ASP Service Guide rev. D